5K2K monitors on a Mac: scaling, refresh and window layouts

5K2K monitors on a Mac: scaling, refresh and window layouts

By · Last updated:

A 5K2K monitor works with any Apple silicon Mac. What decides how it looks is the scaling. The setting most owners want is "looks like 3840 × 1620": sharp, with room for three windows side by side. M1, M2 and M3 Pro and Max chips offer it; M4 and M5 Macs lost it on most 5K2K screens, and many owners report it back on macOS 27.

Set up three columns on your 5K2K screen with Shoji. Draw each at the width you need.

Buy · $4.99
A 40-inch 21:9 screen: notes on the left, a wide center, and an AI chat over a terminal on the right. You can drag the windows too.
In numbers
Size40"
Resolution5120 × 2160 (21:9)
Column widths at 5120 × 2160½ 2560 · ⅓ 1707 · ¼ 1280
Column widths at 3840 × 1620½ 1920 · ⅓ 1280 · ¼ 960
Column widths at 3360 × 1418½ 1680 · ⅓ 1120 · ¼ 840
Column widths at 3072 × 1296½ 1536 · ⅓ 1024 · ¼ 768

5K2K means 5120 × 2160 pixels, 21:9. This page is about LG’s 40-inch 40WP95C (the numbers in the table above are for it), the older 34-inch 34WK95U and the 39-inch OLED 39GX950B, and it explains the scaling choices every 5K2K screen shares. Three other 5K2K monitors have their own pages: the Dell U4025QW, the LG 45GX950A and LG’s newer 40-inch with 120 Hz and Thunderbolt 5, the 40U990A. Everything here was checked on October 10, 2026; reports from owners say so and link to the thread.

Which scaling to pick

At native 5120 × 2160, macOS runs the screen at 1×, without Retina scaling. On the 40-inch LG that’s 140 pixels per inch (LG), so text comes out smaller than on a 27-inch 1440p monitor, which has about 109. The sharp “looks like” modes draw everything at twice the size and scale it down, so “looks like 3840 × 1620” takes a 7680-pixel-wide image (BetterDisplay wiki). How wide a Mac can go depends on the chip:

Looks like What you get Which Macs
5120 × 2160 The most room, at 1×: small text, not Retina Every Mac
3840 × 1620 Sharp, three comfortable columns M1, M2 and M3 Pro, Max and Ultra; M4 and M5 on macOS 27 for many owners (below)
3360 × 1418 Sharp, a bit bigger The usual limit on M4 and M5 before macOS 27
3008 × 1269 or 3072 × 1296 Sharp, big Where base M1, M2 and M3 stop
2560 × 1080 Exactly 2×, very sharp, everything large Every Mac

The chip limits come from the BetterDisplay wiki and, for M4 and M5, a developer who traced the 3360 cap to the display firmware (smcleod.net, 2026). If a mode isn’t in the list, open System Settings → Displays → Advanced, turn on “Show resolutions as list” and then “Show all resolutions” (Apple).

How big things look depends on the monitor’s size. By our arithmetic, “looks like 3840 × 1620” puts about 105 points in each inch of the 40-inch LG, close to a 27-inch 1440p screen. On the 34-inch 34WK95U the same mode is about 123, so everything looks smaller; there, 3360 × 1418 lands near 27-inch size. On the 39-inch 39GX950B, 3840 × 1620 is about 107.

M4, M5 and macOS 27

In late 2024, M4 owners found that 5K2K monitors “no longer work in HiDPI mode”: on an M4 Max, “3840 x 1620 resolution is missing” (9to5Mac, 2024). The cause is the 3360 cap above, which “M2/M3 machines did not have” (smcleod.net). Owners found one way around it: a monitor that offers 5K at 120 Hz keeps the wider mode (“The condition people found is 5K 120Hz or 8K 60Hz”, BetterDisplay, 2026). That’s why Dell’s 120 Hz U4025QW kept 3840 × 1620 on M4 while the 72 Hz 40WP95C lost it. On base M5 and M5 Pro MacBook Pros, 40WP95C owners got only 3008 × 1269 or native, with 3840 × 1620 marked as low resolution (Apple Community, 2025).

macOS 27, out since September 14, 2026, added “Ultrawide display support”: “Now you can get higher resolutions on ultrawide displays, such as 5K at 120Hz” (Apple). Apple names no chips. Owners report the sharp mode back: “Upgrading macOS tahoe from 26.x to 27.x fixed the issue for me and I can see 3840 x 1620 @ 72Hz on my LG 40” UW monitor” (Apple Community, 2026), and MacRumors owners report the same on M4 and M5 Macs with other 5K2K screens (MacRumors, 2026). One catch from that thread: a base M4 or M5 MacBook Air driving a second external display drops to 3008 or 3072 wide.

The monitors: cable and refresh

Monitor Refresh Cable to the Mac Charges a MacBook Pixels per inch
LG 40WP95C (40”) 72 Hz Thunderbolt 4 or DisplayPort; HDMI stops at 3440 × 1440 96 W over Thunderbolt 140
LG 34WK95U (34”, 2018) 60 Hz Thunderbolt 3 85 W about 163
LG 39GX950B (39” OLED) 165 Hz USB-C (runs as DisplayPort 1.4), DisplayPort 2.1 or HDMI 2.1 90 W over USB-C 143

Sources: LG’s 40WP95C spec table, 9to5Mac’s 34WK95U review (2018; the monitor looks discontinued now) and LG’s 39GX950B spec sheet (March 2026). With the 40WP95C, one Thunderbolt cable is the whole desk: picture, charging and the monitor’s USB ports. Its HDMI inputs are for a second computer, not for the Mac.

The 39GX950B also has a dual mode, 2560 × 1080 at 330 Hz, made for games. We haven’t found an owner report of it on a Mac yet, so its refresh on Apple silicon is unconfirmed. On LG’s 45-inch 165 Hz 5K2K, an M3 Pro got 3840 × 1620 at 165 Hz and an M5 Pro on macOS 26 didn’t (Apple Community, 2026); details on the 45GX950A page.

Common problems

  • 3840 × 1620 isn’t in the list. Turn on “Show all resolutions” first. On an M4 or M5, update to macOS 27. On a base M1, M2 or M3 it won’t appear: those chips stop at about 3072 wide.
  • The 40WP95C isn’t detected over Thunderbolt after macOS 26.1. Owners got it back by switching the monitor’s DisplayPort setting from 1.4 to 1.2, or with Apple’s Thunderbolt cables (Apple Community, 2025). An M1 Mac Studio owner found the old LG cables had “decided to quit”, while Apple and Anker cables worked (Apple Community, 2025).
  • The 40WP95C only offers 3440 × 1440. You’re on HDMI, which LG caps there. Use Thunderbolt or DisplayPort.
  • The 34WK95U shows the wrong resolution or no picture. Set the monitor’s DisplayPort setting to 1.2: the Macs in 9to5Mac’s review “worked with DisplayPort 1.2 enabled”.
  • The screen flickers. Apple says variable refresh “might produce a flickering or stuttering effect”; turn Adaptive Sync off (Apple).

LG’s OnScreen Control or Shoji

LG’s support page for the 40WP95C offers OnScreen Control for macOS, version 7.30 from September 2026 (LG). On some LG monitors it has Screen Split, a set of preset layouts, but LG doesn’t say it works on a Mac for this model, and we couldn’t confirm it. Shoji · window zones for Mac is built for exactly that job, on a Mac:

  • Every screen gets zones. The MacBook’s own screen and a monitor from another maker get their own layouts, not only the LG.
  • You draw the zones. Right on the screen, any size, overlapping if you want, instead of picking a preset.
  • Each monitor keeps its layouts. Shoji recognizes the LG by its hardware and brings them back when you plug it in.
OnScreen Control (Screen Split) Shoji
Monitors Some LG models; Mac support for the 40WP95C unconfirmed Any monitor, including the MacBook’s screen
Zones Preset splits Drawn on the screen, any size, overlapping
Price Free US$4.99 once, 14-day refund

OnScreen Control can stay for the monitor’s settings. If halves and quarters are enough, macOS tiles those on its own, and free Rectangle adds thirds with keyboard shortcuts (Rectangle vs Shoji).

Splitting 5120 × 2160 into windows

macOS tiles windows into halves and quarters only (Apple). At “looks like 3840 × 1620”, half the screen is 1920 points: a whole 1080p monitor for one window. Columns work better. The table at the top has the widths for each mode; in practice:

  • At 3840 × 1620, thirds give each window 1280 points, about the width of a small laptop screen: enough for code, a chat or a browser. A wide center with narrow sides (25 / 50 / 25) is 960 / 1920 / 960.
  • At 3360 × 1418 (an M4 or M5 without the wider mode), thirds are 1120 points and a wide center is 840 / 1680 / 840. Thirds still fit a browser; four columns of 840 get tight.
  • At 3072 × 1296 (a base M1, M2 or M3), thirds are 1024 points. A wide center with sides, 768 / 1536 / 768, gives the main window more room.
  • At the default 2560 × 1080, thirds are only 853 points. Two halves of 1280, or 640 / 1280 / 640, fit better.
  • At native 5120 × 2160, thirds are about 1707 points and four columns are 1280 each, if the small text doesn’t bother you.

The layout in the demo above is notes on the left, a wide center, and the right column split into an AI chat over a terminal. At 3840 × 1620 that right column is 960 points wide and each window in it gets 810 points of height. For more 21:9 layouts, see ultrawide monitors on a Mac.

Set it up with Shoji

  1. Open Shoji and allow Accessibility when macOS asks. Any app needs it to move other apps’ windows.
  2. From the Shoji menu in the menu bar, choose Edit Zones and pick the 5K2K monitor.
  3. Start from Thirds or Center + sides, or drag on the screen to draw your own zones. They snap to a 12 × 8 grid, so thirds land on 4 / 4 / 4 twelfths and a wide center on 3 / 6 / 3.
  4. Save. Hold fn while you drag a window: the zones light up. Let go over one and the window fills it.

The LG keeps its own layouts, and you can have several and switch from the menu bar. If it sits next to a MacBook, the laptop screen has its own zones, and when you unplug the cable, the LG’s layouts wait for it until you plug it in again. More in a different layout on each monitor.

Questions

What’s the best scaling for a 5K2K monitor on a Mac?

“Looks like 3840 × 1620” if your Mac offers it: sharp, and the most room you can get in HiDPI. Native 5120 × 2160 gives more room but runs at 1×, with small text. On a base M1, M2 or M3, the widest sharp mode is about 3072 × 1296.

Why is 3840 × 1620 missing on my M4 or M5 Mac?

M4 and M5 chips cap sharp modes at about 3360 points wide unless the monitor offers 5K at 120 Hz. macOS 27 added higher resolutions for ultrawide displays, and many owners got 3840 × 1620 back after updating. Turn on “Show all resolutions” after the update.

Does a 5K2K monitor work with a MacBook Air?

Yes. The M1 and M2 Air drive one external display up to 6K at 60 Hz (Apple), and the M5 Air up to 5K at 120 Hz (Apple). On M1, M2 and M3 Airs, sharp modes stop at about 3072 points wide. Owners report M5 Airs reaching 3840 × 1620 on macOS 27 with one external display, and M4 and M5 Airs dropping to 3008 or 3072 wide with two (MacRumors, 2026).

Can the LG 40WP95C charge my MacBook?

Yes, up to 96 W over the same Thunderbolt cable that carries the picture (LG).

Does a 5K2K monitor run at 120 Hz on a Mac?

It depends on the monitor. The 40WP95C tops out at 72 Hz and the 34WK95U at 60. Dell’s U4025QW runs at 120 Hz on M2 Pro, M3 Max and M4 Macs, by owners’ reports (U4025QW page). LG’s 40U990A needs a Mac with Thunderbolt 5 for 120 Hz, LG says; an M4 Pro owner gets it, an M3 Air owner gets 100 Hz (40U990A page, checked October 20, 2026). The 39GX950B is rated for 165 Hz, but we haven’t found a Mac owner’s report yet.

Shoji · window zones for Mac

Draw zones on each monitor, drag a window over one, and it snaps in. $4.99 once; if it isn't for you, your money back within 14 days.

$4.99 once · one Mac · macOS 15 or later

Shoji requires a license to use. You get the key by email when you buy.